22
BA 68
Schaeffler Technologies
Schaeffler OPTIME
In the case of machines that are significantly larger than 0,5 m, it is
recommended that at least two sensors be used so that potential
damage can be readily identified. The same applies if two machine
components are separated by a coupling, as in this case the
vibrations cannot be transmitted adequately via the coupling.
Mounting position
Alternative mounting position
Figure 12
Examples of
mounting positions for
small and large motors
MM
⬎ 0,5 m
2⫻
MM
⬉ 0,5 m
1⫻
1
2
Figure 13
Examples of
unsuitable mounting positions
To Next Page
Loading...
