EasyManua.ls Logo

Schaerer Ambiente 1

Schaerer Ambiente 1
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Error messages and malfunctions
BASO 1 MS - 02.06 - V02 Page 6-5
Display Cause Rectification
grinder left blocked
(sTxt-168)
- An object (e.g. a stone) is stuck in the
grinder.
Left coffee outlets are disabled
- Press the [ ] / STOP button.
- If the message persists, disconnect the
coffee machine from the power mains.
Vacuum the coffee beans out of the
grinder. Check the grinder for stuck ob-
jects.
-If the problem still persists, contact an
authorised customer service representa-
tive.
grinder right blocked
(sTxt-169)
- See "grinder left blocked".
Right coffee outlets are disabled.
- See "grinder left blocked".
level probe steam
(sTxt-191)
- The water level in the steam generator is
wrong.
Steam discharge is blocked.
- Check whether the stop valve of the water
mains is open.
- If the problem still persists, contact an
authorised customer service representa-
tive.
Gr. container not in place
(sTxt-189)
- The coffee grounds container is not in its
compartment.
- The coffee grounds container is not in its
proper final position.
- Limit switch is defective.
Kaffeemaschine ist blockiert.
- Push coffee grounds container fully into
coffee grounds container compartment.
- Check whether the coffee grounds con-
tainer is fully inserted into the coffee
grounds container compartment. If neces-
sary, remove the coffee grounds residue
from the back panel and base plate of the
coffee grounds container compartment.
- If the message persists, contact a manu-
facturer-authorised customer service rep-
resentative.
clean grounds container
(sTxt-183)
- The coffee grounds container is full.
The coffee machine is blocked.
- Empty the coffee grounds container.
grounds container full
(sTxt-173)
- You can still serve 5 products before the
espresso machine gets blocked.
- Empty the coffee grounds container.
system error
(fix-013)
- Programming error
Products can still be served.
-You can temporarily remove this message
by pressing the
[ ] / STOP button.
- Contact a manufacturer-authorized cus-
tomer service representative immediately.
temp. probe steam
(sTxt-177)
- The temperature sensor in the steam gen-
erator is defective.
Steam discharge is blocked.
-Contact a manufacturer-authorised cus-
tomer service representative.
replace waterfilter
(sTxt-196)
- The programmed water quantity has flowed
through the filter. The control unit has acti-
vated the display message
Products can still be dispensed.
-The water filter must be replaced.
- If you do not have a replacement water
filter, contact a manufacturer-authorised
customer service representative.

Table of Contents

Related product manuals