Schaerer Coffee Prime - Machine Interface and Beverage Selection

www.schaerer.com Operation
BASCP_EN
V08 | 08.2018
28
Option 1: Side cooling unit
Connecting:
► Connect side cooling unit with separate mains cable to the rear [A].
► Connect level monitoring on the rear [B].
Switching on:
► Open doors.
► Switch toggle switch [A] to position [I].
► Press and hold button [B] ±3 sec.
 The device is switched on.
Temperature setting:
► Press and hold button [C] until the current temperature flashes.
► Increase the set temperature using the [B] button or reduce using the Setting button [D].
► Button [C] saves the setting.
► Close the door.
Option 2: Under-machine cooling unit
Connecting:
► Connect the under-machine cooling unit at the rear using the separate mains cable
Switching on:
► Open doors.
► Switch on the toggle switch on the bottom.
 The switch lights up green.
Temperature setting:
 The temperature is preset at the factory.
 The thermostat (A) is located on the rear for any necessary temperature adjustments.
► Close the door again.
Main window touch screen
Overview
Main view:
Observe the operating instructions for the side cooling unit.
See "Operator control" - "Filling and connecting" - "Milk" - "Option: Additional cooling unit".
Be sure to observe the operating instructions for the under-machine cooling unit.