Schenker MODULAR 150 User Manual

5 – FUNCTIONING AND USE COD.60M12/24.A.2018
EN
THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
38
13.3 Manual washing procedure
NOTE
Manual washng is a procedure adviced only in case of long term inactivity of the watermaker (2/3
months could be considerate a period of time that requires a manual washing).
NOTE
During manual washing the watermaker does not produce fresh water. Indeed the procedure has the
goal to rinse the system before long period of inactivity.
CAUTION
Before performing a manual washing procedure, please verify to have an adequate reserve of fresh
water in the tank before proceeding, taking into account that for a correct washing an amounth of
10lit/min will last, for at least 10 minutes of washing.
1. Switch on both pumps by rotating clockwise
the Pump 1 and Pump 2 selector.
2. Switch off the Automatic Washing selector.
(AUT.WASHING in vertical position)
3. Push the button MAN. WASHING to start the
washing cycle. The green led (START) and
the blue led (MAN. WASHING) will switch on
and the procedure starts.
4. Push the STOP button to end the flushing
procedure after around 10 minutes.
.
CAUTION
It is advisable to not exceed 10 minutes manual washing, being it an adequate time to correctly rinse
the membranes and guarantee the complete removal of the salt in the watermaker.

Schenker MODULAR 150 Specifications

General

Brand	Schenker
Model	MODULAR 150
Category	Water Filtration Systems
Language	English