Schenker MODULAR 150 User Manual

6 – MAINTENANCE (ROUTINE AND EXTRAORDINARY) COD.60M12/24.A.2018
EN
THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
48
6.7 Periodic maintenance
6.7.1 Membrane replacement
Reverse osmosis membranes have an average lifetime of about 7 years If correctly maintained. It is anyway
recommended to check the efficiency of the membranes after 5 years of functioning and verify the needed of
a replacement. Please, refer to a certified Schenker service center for this operation.
6.8 Adjustments
Pump high pressure switch
The main pump is equipped with a high pressure switch set
at around 9,5 Bar.
The pressure switch can be calibrated with a 2 mm
hexagonal key. To have access to the calibration screw it is
necessary to operate on the screw that blocks the electrical
connector of the pressure switch, and then introduce the
hexagonal key (even without removing the electrical
connector itself). Turning the key clockwise increases the
calibration of the pressure switch, while turning the key
anticlockwise decreases the calibration.
Pulsation dampener
It is a balder type cylindrical pressure accumulator of air
that has the function of damping the pressure oscillations
during the commutations of the watermaker. The dampener
is factory loaded at a pressure of about 4 bar. The charge
level of the dampener must be periodically checked in order
to guarantee a correct functioning to the watermaker.

Schenker MODULAR 150 Specifications

General

Brand	Schenker
Model	MODULAR 150
Category	Water Filtration Systems
Language	English