EasyManua.ls Logo

Schenker MODULAR 150 - Periodic Maintenance; Membrane Replacement; Adjustments

Default Icon
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6 MAINTENANCE (ROUTINE AND SPECIAL) COD.150M230.T.2021
EN
THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
47
6.7 Periodic maintenance
6.7.1 Membrane replacement
Reverse osmosis membranes have an average lifetime of about 7 years If correctly maintained. It is anyway
recommended to check the efficiency of the membranes after 5 years of functioning and verify the needed of
a replacement. Please, refer to a certified Schenker service centre for this operation.
6.8 Adjustments
Pump high pressure switch
The main pump is equipped with a high pressure switch set
at around 15 Bar.
The pressure switch can be calibrated with a screwdriver. To
calibrate the pressure switch pull out the plug, remove the
security nut, and engage the small internal screw with a small
screw driver.
Turning clockwise the calibration of the pressure switch
increases, while turning anticlockwise the calibration
decreases.
Accumulator
It is a SS reservoir of air that has the function of damping the
pressure oscillations during the commutations of the
watermaker. The accumulator is factory loaded at a pressure
of about 9 bar. The charge level must be periodically checked
in order to guarantee a correct functioning to the watermaker.

Table of Contents

Related product manuals