www.scheppach.com
GB
|
21
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
•
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
not hang on the power network during the inspection.
-
-
AC motor
• The mains voltage must be 220 - 240 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
2
.
Please provide the following information in the event
•
•
•
12. Cleaning, maintenance, and storage
m Important!
from electric shock!
m Important!
-
m Important!
-
• The button (3) allows the desired pressure to be
increased.
• Switch the device on as described in 10.2. The
compressor will then pump until the preset pres-
10.5 Establishing connections (g. 2 - 4)
m Attention!
10.5.1 Using the adapter set
The adapter set enables the following additional
• Pumping up balls with the help of the ball needle
(7).
•
• Filling pools, air mattresses, boats or similar
swimming accessories is also possible with the
help of the additional conical adapter (8).
Warning! Observe the information supplied by
the tire manufacturer and the vehicle manufac-
turer relating to the recommended tire pressure.
Warning! This equipment is not calibrated! For a
calibrated measurement value, check the actual
tire pressure using a calibrated meter after you
have inated the tires yourself, e.g. at a petrol
station.
10.5.2 12V socket (Fig. 8)
1. Press the selector switch (11) to switch between
2.
via the mains cable.
3.
4. The compressor can be connected to a 12V so-
cket in the car. To do so, plug the connector (15)
11. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions.
The customer‘s mains connection as well as
the extension cable used must also comply with
these regulations.
connected to a residual current circuit breaker with a
trigger current of 30 mA or less.
To Next Page
Loading...
Need help?
General
