OPERATION
28 | EN www.schmalz.com 30.30.01.01117/06
Danger due to falling objects in the event of:
The load breaking off due to a collision
Component failure resulting from overload or unauthorized
modifications
There is a risk of death or serious injury from hitting people in the vicinity.
No person may sit or stand in the danger zone of the load.
Suitable protective equipment must be worn prior to transport.
Do not operate unless you have a clear view of the entire working area.
Never lift loads at an angle and never drag or pull them.
Cordon off the working area.
The maximum lift capacity must not be exceeded.
Never transport the load above people.
The swiveling point of the load must always be located within the working area
of the crane.
Starting a movement in high gear can lead to premature wear of the sliding clutch. It is
recommended to start each movement in low gear.
6.2 Attaching the Chain Hoist
When attaching the chain hoist, observe the operating instructions for the load suspension. The
maximum lift capacity of the load suspension must not be exceeded.
6.2.1 SCH-S and SCH-M Model
Hook the chain hoist with the suspension eye on the load suspension.
To Next Page
Loading...