SCHUNK SWS Series - Fastening the Quick-Change Adapter (SWA); Tightening Torque

Assembly
28
10.00 | SWS 005 – 300 | Assembly and Operating Manual | en | 389456
Size screws (1) Quantity
040Q M5 x 45 / DIN EN ISO 4762 6 *
041 M5 x 40 / DIN EN ISO 4762 6 *
046 M6 x 40 mm / DIN EN ISO 4762 6 *
060 M6 x 40 / DIN EN ISO 10642 6 *
071 M6 x 40 / DIN EN ISO 4762 6 *
076 M10 x 55 / DIN EN ISO 4762 6
110 M10 x 50 / DIN EN ISO 4762 6
150 M10 x 60 / DIN EN ISO 4762 6
160 M10 x 60 / DIN EN ISO 4762 6
300 M12 x 70 / DIN EN ISO 4762 6
* screws are contained in the accessory pack
5.4.2 Fastening the quick-change adapter (SWA)
Size of the fastening screws
Size SWA
005/007/011 020/021 040/040Q/
041/046/060/
071
076/110/
150/160
300
M5 M6 M8 M10 M12
5.4.3 Tightening torque
NOTE
The listed tightening torques are recommendations. The material
of the adapter plates and the conditions during the assembly must
be always taken into account.
Size 005, 011
Type of Screw Thread Size Strength Class Tightening
Torque [Nm]
Thread Locker
Robot-side adapter plate on SWK
Socket head cap M3 12.9 1.2 Loctite 222
Tool-side adapter plate on SWA
Socket head cap M5 12.9 5.1 Loctite 222
Socket flat head cap 4