Maintenance and Care
10.00 | SWS 005 – 300 | Assembly and Operating Manual | en | 389456
61
8.7.2 Disassembly of SWK 020 - 300
WARNING
Risk of injury due to unexpected movements!
If the power supply is switched on or residual energy remains in
the system, components can move unexpectedly and cause
serious injuries.
• Before starting any work on the product: Switch off the power
supply and secure against restarting.
• Make sure, that no residual energy remains in the system.
Ø Remove the compressed air and the connectors.
Ø To remove the SWK remove the screws (20) from the handling
tool.
Ø Separate the SWK from the adapter plate.
Ø Unscrew the screws (10) and remove them from the piston
cover (8).
Ø Remove the O-ring (6) from the countersink in the housing (1).
Ø Remove the screw completely (17).
Ø Remove the locking piece (16).
NOTICE!Make sure that the balls (12) will remain in their
given position.
Ø Carefully push the piston (8) out of the housing (1).
Ø Remove the seal (7) from the piston (8).
Ø Remove the screws (15) and pull the ball fixation (13) out of the
housing (1).
Ø Remove the O-ring (19) from the ball fixation of the housing (13).
Ø Remove the rubber bushing (21) from the housing (1).
NOTICE!Exception: For the SWS-020, these rubber bushings
are not inside of the SWK but in the SWA!
To Next Page
Loading...
