Maintenance and Care
56
10.00 | SWS 005 – 300 | Assembly and Operating Manual | en | 389456
NOTICE
For SWS-021 models, the rubber bushings must be installed
with Loctite 454®.
A thin film of adhesive should be applied around the diameter of
the counter bore in the body prior to installation; do not apply
the adhesive to the bushing itself. The dry rubber bushing should
then be installed by hand or utilizing soft-faced mallet, if
necessary, as described in steps 4 and 4.
Ø Press the bushing in by hand until it is seated completely in the
bore. If necessary, use a plastic or rubber soft-faced mallet to
tap the bushings into place.
For larger models with G 3/8" and G 1/2" ports, the rubber
bushings require a brass sleeve to retain the bushings in the body.
Ø Remove damaged rubber bushing by grasping with a pair of
needle-nosed pliers and pulling the bushing out of the body.
Ø Upon removal of the rubber bushings, remove the brass sleeve
from the damaged bushing.
Ø Install the rubber bushings as previously described in steps 2–4
for the smaller ports.
Ø Insert the beveled end of the brass sleeve into the rubber
bushing.
Ø Do not use excessive force when pressing in the brass sleeve;
too much force can damage the body.
Press the brass sleeve into the bushing, using an 10mm Allen
key, until it makes contact with the body. Press the brass sleeve
only until a firm resistance is felt, then stop pressing.
Ø Inspect the bore and remove any rubber slivers that may have
resulted from installation of the brass sleeve.
To Next Page
Loading...
