General
10.00 | SWS 005 – 300 | Assembly and Operating Manual | en | 389456
9
Size Designation ID number for electrical option (1)
041 SWD-041-R00-000 0302255 R19/R26 (connection side A)
060 SWD-060-K00-000 0302256 K19/K26 (connection side A)
071 SWD-071-R00-000 0302257 R19/R26 (connection side A)
076 SWD-076-000-R00 0302258 R19/R26 (connection side B)
110 SWD-110-R00-000 0302260 R19/R26 (connection side A)
150 SWD-150-R00-000 0302261 R19/R26 (connection side A)
In order to avoid contamination of the pneumatic feedthrough
openings, as well as of the contacts of the electric options at the
SWA quick- change tool, an SWD dust cover has to be used while it
is located in the storage rack.
The SWD is equipped with an integrated clamping device, which is
actuated by locking/ unlocking the SWK quick-change head.
Hereby the SWD dust cover can be removed from the SWA quick-
change adapter and can be located onto a further SWA quick-
change adapter.
The SWD dust cover (material PA2220) is protecting the SWA
quick-change adapter against the following contaminations:
• Dust
• Chips
• Various liquids (e.g. coolant)
NOTE
• The SWD dust cover is only suitable for covering the SWA quick-
change tool. It never should be used for transporting the SWA
quick-change tool together with the attached tools.
• If the SWD dust cover should be used in extremely dirty
conditions, an excessive filling of the interior of the SWK quick-
change master mounting with dirt particles has to be avoided.
Therefore, regular control and possible cleaning of the SWK will
be necessary.
• In case of excessive contamination there will be the risk that
the locking mechanism of the SWK will not completely move
into its final position, and the SWD will get damaged.
To Next Page
Loading...
