ELSA
4.
Withdraw U-Clip (4) and remove hood connector from inlet fitting on hood (1).
6.5
FIT BREATHING HOSE CONNECTOR TO HOOD
1.
Check to confirm that hood connector is in good condition, clean and free from
grease.
2.
Locate hood connector into inlet fitting on hood (1) and secure in position using
U-Clip (4).
3.
Ensure that exhale valve O-Ring has been lightly lubricated with Krytox Grease
(A) and push exhale valve assembly (2) into exhale valve fitting on hood (1).
Issue F 11. 2009
ELSA
(Page 7)
To Next Page
