INTRODUCTORY NOTES IN-1
WARNINGS
Please Read Carefully and Fully Understand
This Service Manual is for use by personnel who have successfully completed a
recognised training course in, and hold a current certificate for, the servicing of
breathing apparatus supplied by Scott Safety Limited. Unqualified
personnel MUST
NOT service breathing apparatus.
Scott Safety Limited have taken great care to ensure that the information
contained
within this Service Manual is accurate, complete and clear. However, Training
and Technical Support Services will be pleased to clarify any points in this
Manual
and answer questions of a general nature on breathing apparatus.
Failure to adhere to the above instructions may result in the cancellation of the
certificate for servicing breathing apparatus supplied by Scott Safety Limited.
The following warnings are in accordance with certifying authority requirements and
apply to the use of breathing apparatus in general:
In toxic atmospheres where the contamination is likely to exceed minimum levels, reference
should be made to EN 529 : 2005 and the Health and Safety Executive publication HS(G)53 -
Respiratory Protective Equipment, a Practical Guide for Users.
The quality and purity of air used to supply and charge compressed-air breathing apparatus
must meet the requirements of EN 12021 :2014.
Observe all existing regulations regarding the use of Pressure Systems and Transportable
Gas Regulations. These regulations will not only apply to compressed-air cylinders and
vessels where used, but also to the supply hoses.
To ensure operational readiness, it is strongly recommended that breathing apparatus which
is not in regular use should be tested in accordance with the instructions given in the Service
and User Instruction Manuals; and operated at monthly intervals.
Apparatus that fails a routine check or any of the tests detailed within this Manual MUST be
withdrawn from service until the fault is identified, rectified and all tests and routine checks
have been passed successfully.
Fully de-pressurise the pneumatic system and disconnect from air supply prior to servicing
pneumatic components.
Wear suitable eye protection when working with compressed-air equipment.
Registered Office: Scott Safety Limited, Pimbo Road, West Pimbo, Skelmersdale,
Lancashire, WN8 9RA, England.
Issue A 01. 2009
IN-1
(Page 1)
To Next Page
Loading...
