CODED SIGNALS POSSIBLE CAUSE REMEDY
Watercraft is upside down. Turn watercraft upright.
Refer to SPECIAL
PROCEDURES.
Engine coolant temperature
sensor or circuit
malfunction.
Fuel level sensor or circuit
malfunction.
Exhaust temperature sensor
or circuit malfunction.
Engine oil pressure sensor
or circuit malfunction.
Low pressure in oil
separator tank (engine
oil leak).
TOPS sensor or circuit
malfunction.
TOPS valve solenoid or
circuit malfunction.
EMS ECU failure.
Bilge pump circuit low or
high voltage (if so equipped).
A 2 seconds beep every 15
minutes interval.
Starter solenoid circuit
malfunction.
Refer to an authorized
Sea-Doo dealer.
High engine temperature
coolant.
See engine OVERHEATING.Continuously beeps.
High exhaust temperature. Refer to an authorized
Sea-Doo dealer.
Information Center Messages
OBSERVATION POSSIBLE CAUSE REMEDY
The information center
display abbreviated
messages that I don’t
understand.
Some messages are useful
navigational information and
others may be system fault
information.
Refer to INFORMATION
CENTER in CONTROLS,
COMPONENTS
AND INSTRUMENTS
FUNCTIONS.
No numbers are displayed
in the usual display and only
P-XXXX numbers appear in
the message area.
EMS ECU has been
mistakenly set to onboard
diagnostic mode.
Remove and reinstall safety
lanyard.
104
_____________________
Print Preview Version 8.0 PubTeX output 2003.11.07:1153 File: C:\TEMP\.aptcache\smo2004-003en/tfa00394.dvi User: CASS2 Page: 106
To Next Page
Loading...
Need help?
General