WARNING
When operating the engine while
the watercraft is out of the water,
theheatexchangerintherideplate
may become very hot. Avoid any
contact with ride plate as burns
may occur.
F18L0TY
ALL MODELS EXCEPT RXP
F19J01Y
1
RXP MODELS
1. Flushing connector
On some models, an additional flush-
ing connector is located in engine
compartment to allow flushing while
watercraft is on a lift or if you prefer to
flush from this location, either flush-
ing connector can be used to flush
the exhaust cooling system. Remove
seat to gain access.
1
F18E1TY
2
SOME MODELS
1. Flushing connector
2. Dust cap
Refer to POST-OPERATION CARE
section for proper use.
30) Bilge Drain Plugs
Should water be found in the bilge, it
can be easily drained by unscrewing
the drain plugs when engine is off and
watercraft is out of water.
CAUTION:
Remove
boatwater-
craft
from water prior to unscrew-
ing drain plugs.
48
______________________
Print Preview Version 8.0 PubTeX output 2003.11.07:1153 File: C:\TEMP\.aptcache\smo2004-003en/tfa00394.dvi User: CASS2 Page: 50
To Next Page
Loading...
Need help?
General