EasyManuals Logo

SeaDoo RXP 4-Tec Supercharged User Manual

SeaDoo RXP 4-Tec Supercharged
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
Safety Lanyard and
Engine Start/Stop Button
Position shift lever in neutral. Ensure
that both switches operate properly.
Start engine and stop it using each
switch individually.
WARNING
Should the safety lanyard cap is
looseorfailtoremainonitspost,
replace it immediately in order to
avoid unsafe use.
Water Flow in Exhaust
Manifold (only when
temperature is below or
close to freezing point)
In Northern areas, if watercraft is to
be used when temperature is below or
close to freezing point (0°C(32°F)) or if
watercraft was left unused while tem-
perature was below or close to freez-
ing point, water may be frozen in the
supply hose going to the exhaust man-
ifold. This could cause exhaust cool-
ing system overheating. To ensure it
is properly working, do the following
prior to using the watercraft:
The procedure is to be performed
with watercraft out of water.
Connect a garden hose to the flush-
ing connector at jet pump.
Perform the flushing operation as
explained in POST-OPERATION
CARE.
Ensure water flows out of jet pump.
Otherwise, water is frozen in sup-
ply hose and restricts water flow.
Do not operate the watercraft in
this condition.
NOTE: Pay attention that some water
will also flow out of exhaust outlet.
Make sure water is effectively flowing
out of jet pump.
CAUTION:
Operating watercraft
with frozen water in supply hose
might lead to engine components
damage.
NOTE: When water freezes, no dam-
age to engine components will occur
as water expands but it may cause
damage by preventing full flow of cool-
ing water.
Either wait until ice melt or pour
some hot water on supply hose go-
ing to exhaust manifold. Then, per-
form the flushing operation again
to make sure water properly flows
out of jet pump. If you need as-
sistance, refer to an authorized
Sea-Doo dealer.
WARNING
Do not use any electrical heating
device to heat the hose. Electrical
devices may generate sparks that
would ignite fuel vapors that might
be present in the bilge causing a
fire or an explosion.
Ensure to drain bilge if water is
present.
66
______________________
Print Preview Version 8.0 PubTeX output 2003.11.07:1153 File: C:\TEMP\.aptcache\smo2004-003en/tfa00394.dvi User: CASS2 Page: 68
www.SeaDooManuals.net

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SeaDoo RXP 4-Tec Supercharged and is the answer not in the manual?

SeaDoo RXP 4-Tec Supercharged Specifications

General IconGeneral
SuperchargerYes
ManufacturerSea-Doo
ModelRXP 4-Tec Supercharged
CategoryPersonal Watercraft
Fuel TypeGasoline
CoolingClosed-loop cooling system
Fuel Capacity15.9 US gallons (60 l)
Width48 inches
Seating Capacity2
Oil Capacity3.5 liters
Storage Capacity10.7 US gal