1
F18L09Y
1. Engine start/stop button
5) Variable Trim
System (VTS) Button
(if so equipped)
Located just below the engine
start/stop button, this button is used
to change pump jet nozzle position
andtoadjustridetosuitwatercraft
load and water conditions.
F19L01Y
1
1. VTS button
A VTS position indicator is included in
the information center gauge. See IN-
FORMATION CENTER in this section.
6) Shift Lever
A push-pull lever:
– forward
– neutral
– reverse.
WARNING
Shift lever should only be used
whentheengineisidlingandcraft
is completely stopped. Do not use
as a grab handle.
WARNING
Only use reverse at slow speed
and for the shortest time possible.
Always ensure the path behind
is clear of objects and persons
including children playing in shal-
low water.
CAUTION:
Never rev the engine at
high RPM in reverse.
From the forward position, pull the
lever to reverse. Push back to go to
forward. Always set in forward when
finished. To find the neutral, set in re-
verse then push back until the water-
craft stops moving backwards.
1
F18J01Y
1. Forward position
_____________________
35
Print Preview Version 8.0 PubTeX output 2003.11.07:1153 File: C:\TEMP\.aptcache\smo2004-003en/tfa00394.dvi User: CASS2 Page: 37
To Next Page
Loading...