F18E0OY
1
1. Vent tube
Lift lock tab and holding the tab, pull
the tube to release it.
F18E0PY
1
1. Lift lock tab
Then proceed with the tab under the
tube. Refer to the following illustra-
tion to see it.
F18E0QY
1
1. Other lock tab under tube
Snugly install the hose pincher on the
water supply hose as shown.
1
F18E0RY
TYPICAL
1. Hose pincher
NOTE: A red tape on the water supply
hose indicates which hose to pinch.
CAUTION:
When finished towing
the watercraft, hose pincher must
be removed before operating it.
Failure to do so will result in dam-
age to the engine.
After removal of hose pincher, prop-
erly reinstall and lock vent tube. When
pushing tube in place, you should hear
a click that validates it is locked.
Low-Charge Battery
Condition
See an authorized Sea-Doo dealer to
have it charged or replaced.
WARNING
Do not charge or boost the battery
while installed on the watercraft.
Electrolyte is poisonous and dan-
gerous. Avoid contact with eyes,
skin and clothing.
84
______________________
Print Preview Version 8.0 PubTeX output 2003.11.07:1153 File: C:\TEMP\.aptcache\smo2004-003en/tfa00394.dvi User: CASS2 Page: 86
To Next Page
Loading...