Limited-Speed Operation
The 4-TEC models also offers a special
safety lanyard -- the SEA-DOO Learn-
ing Key
TM
-- which electronically lim-
its the speed of the watercraft to ap-
proximately 55 km/h (35 MPH) there-
fore enabling first time users and less
experienced operators to learn how to
operate the watercraft while gaining
the necessary confidence and control.
F00L2SY
2) Handlebar
The handlebar controls the direction of
the watercraft. Turning the handlebar
to the right steers the watercraft to the
right and inversely.
WARNING
Check handlebar and correspond-
ing steering nozzle and side vanes
operation before starting. Never
turn handlebar while someone is
nearby rear of watercraft. Keep
away from steering moving parts
(nozzle, side vanes, linkage etc.)
Adjustment (if so equipped)
The handlebar height can be adjusted
to suit rider preferences.
To perform this adjustment, turn the
knob underneath the handlebar.
1
F18K18Y
TYPICAL
1. Adjustment knob
3) Throttle Lever
When the throttle lever is squeezed,
the watercraft accelerates. When
fully released, engine automatically
slows down to idle speed and water-
craft is gradually stopped by water
drag.
4) Engine Start/Stop
Button
To start engine, depress and hold the
start/stop button. Release immedi-
ately after engine is started.
To stop engine, depress the start/stop
button. When stopped, disconnect
safety lanyard from the post. It is
suggested to release throttle lever
first.
WARNING
Directional control is reduced
when the throttle is released or
when engine is off.
34
______________________
Print Preview Version 8.0 PubTeX output 2003.11.07:1153 File: C:\TEMP\.aptcache\smo2004-003en/tfa00394.dvi User: CASS2 Page: 36
To Next Page
Loading...
Need help?
General