Seaga JDL-2 COMBO - Error Code Messages; VMC Errors

50JDL V1.0 8 2022
MANUAL DEFROST
Note: Do not use unless requested by trained personnel
1. Press Service Mode Buon
2. Press 0 for Test Modes
3. Press 5 for Manual Defrost, which will enable you to set a manual defrost period for the machine
4. Press 5 to toggle ON/OFF
5. Press # to save changes
6. Press * to exit to previous menu
DOOR SWITCH
1. Press Service Mode Buon
2. Press 0 for Test Modes
3. Press 7 for Door Switch
4. Operate the door switch by hand and conrm on display
5. Press * to exit to previous menu
ERROR CODE MESSAGES
VMC Errors
Error Message Descripon Possible Soluons
VMC Sengs Reset VMC has been reset to factory
default.
If a soware upgrade has just been performed,
the VMC has been reset to default sengs.
Change your prices and other sengs as
required. Cycle power and verify your changes
and any error messages.
VMC Door Switch Door switch is seen as open for
greater than the allowed me.
Check the door switch for correct operaon.
Check door wire harness.
VMC Scale Factor There is a conict with one or
more MDB seng from the
installed MDB devices.
Review manuals and sengs for installed MDB
devices to make sure they are compable.
VMC Selecon SW A keypad selecon buon is stuck
in the depressed posion.
Determine reason why keypad buon is stuck
and repair.
VMC Low AC The incoming AC power is lower
than required to properly run your
vending machine.
Determine why voltage is low. Remove any
voltage reducing devices not authorized by the
vending machine manufacturer.
VMC RAM Checksum A RAM checksum error indicates
that accounng data or a VMC
seng was in error. The VMC will
use a backup copy of the data
where possible.
Check the VMC sengs and accountability
data for correctness. Cycle power to the
vending machine and recheck error messages.