Seaga JDL-2 COMBO - Motor and Sensor Errors; Motor Errors

51JDL V1.0 8 2022
Motor Errors
Error Message Descripon Possible Soluons
Motor [Number] Open The motor indicated or harness to
that motor has an open electrical
connecon.
Check the motor and motor harness
for open connecons. Test vend motor.
Replace if necessary.
Motor [Number] Short The motor or harness has an elec-
trical short.
Check motor and motor harness for
short. Replace if necessary.
Motor [Number] Home Sns The motor home switch was not
detected while the motor was in
operaon. This may also indicate a
motor jam condion.
Check motor type service mode seng,
motor, motor switch and then spiral for
blockage. Test vend selecon motor if
necessary.
Motor [Number] Jam A motor jam has been detected. Check motor and spiral for blockage.
Motor [Number] Errors One or more motor errors have
been detected.
Test vend selecon motor and review
informaon on motor open, short, home
switch and jam condions.
Motor Under Voltage The detected motor voltage is not
high enough to run the selecon
motors.
Test vend selecon motor for correct
operaon. Replace motor. Replace VMC.
Temperature Sensor Errors
Error Message Descripon Possible Soluons
Refrig Sensor # Open A temperature sensor or harness is
considered to have an open elec-
trical connecon. Where # is the
sensor number.
Check sensor and sensor harness for
open connecons. Check for sensor
readings. Replace sensor if necessary.
Refrig Sensor # Short A temperature sensor or harness
is considered to have an electri-
cal short. Where # is the sensor
number.
Check sensor and sensor harness for
shorted connecons. Replace if neces-
sary.
Refrig Health Safety The cabinet temperature and me
limit sengs have been exceeded.
Check sensor readings and sensor
harness for shorted connecons. Check
for sensor readings. Replace sensor if
necessary.
Vend Sensor Errors
Error Message Descripon Possible Soluons
Opcal Sensor Error Not Applicable NA