Seaga JDL-2 COMBO - Page 67

67JDL V1.0 8 2022
and you will see a series of nuts in each corner of the mounng plate. Loosen each one of those a half to full
turn. Power the machine o for 10 seconds then power back up and test the keypad.
Changer
My vendor won’t accept change, how do I x this?
1. Check to make sure the changer has power.
2. Check your payment device seng and make sure that the changer is enabled.
3. Check to make sure there are no coins jammed in the changer.
4. Check to make sure the coin return mechanism is releasing all the way.
What does it mean when the lights on top of the changer are ashing?
1. If the amber C/C light is ashing, it means that the lower coin cassee is not fully engaged. Remove
the lower coin cassee, line up correctly and reinsert.
2. If the red DIS light is ashing, it means that there is a jam located in the upper cassee. You can
clear that by opening the clear center access door or opening the ap on top to check for interior
jams.
Bill Validator
My vendor won’t accept bills, what do I do?
1. Make sure the bill acceptor is clean and there are no jams or debris inside of the acceptor.
Beverage Vending
My beverages aren’t vending at all.
1. Make sure all items are loaded correctly.
2. Make sure shim is in correct place and back gate is adjusted properly.
Power
I can see and hear the cooling deck fans, but there is no power to the rest of the machine. What does this
mean?
1. Check the transformer on the oor of the machine. There is a cover that goes over the transformer
with access to the small breaker switch on top of the transformer. Press the breaker switch to reset
the transformer. This should cause the machine to power back up.
Check to make sure that the main power harness that runs from the transformer to the VMC. Make sure all
connecons are good.