NOTE: Please contact your garage door manufacturer if your garage door
needs reinforcement kit. Many door reinforcement kits provide for direct attachment
of the clevis pin and door arm. In this case you will not need the door bracket;
proceed to the next step.
6.1 Keep the door in the closed position.
6.2 Align the door bracket to the center line of the top section 2” to 4” below the top
edge of the door. Mark mounting points.
6.3 Drill 3/16" fastening holes, Secure the door bracket by using the four
self-threading screws (H8). Pay attention on your doors construction:
5.8 Open and close the door
manually. If the door hits the rail, lift
the header bracket.
To Next Page
Loading...
