Seaside 9357 - Important Installation Warnings

4
 This garage door operator is designed to operate only at 120V, 60 Hz to avoid
malfunction and damage.
CAUTION
IMPORTANT INSTALLATION INSTRUCTIONS
To prevent any possible SERIOUS INJURY or DEATH:
1. Read and follow all installation instructions.
2. Always call a professional qualified door technician to make repairs to garage
door cables, spring assemblies, and other hardware before installing the
operator. This operator only works with a properly balanced garage door.
3. Never try to adjust garage doors, springs, cables, pulleys, rollers, brackets or
other door hardware, unless you are qualified to do so.
4. Make sure you have another access door besides garage door. If not, you must
install an emergency release kit that can be operated outside.
5. Remove all ropes and remove or make inoperative all locks connected to the
garage door before installing the operator.
6. Do not connect the operator to power source until instructed to do so.
7. Use this operator only with Sectional Door.
8. Contact the garage door manufacturer to see if additional reinforcement is
needed to support the door before installation of the operator.
9. If possible, install the operator 7 feet(2.1m) or more above the floor and the
center of the door. Mount the emergency release knob 6 feet above the floor
and avoid contact with any moving object.
10.Install the wall control:(a)within sight of the door,(b)at a minimum height of 5
feet(1.5m) above the floor that small children cannot reach it.(c)away from all
moving parts of the door.
11.Attach the warning label next to the wall control in a prominent location. Attach
the hanging warning label to the emergency release knob.
12.After installing the operator, the door must reverse when it contacts a 3.8cm(or
a 2x4 laid flat)on the floor.
13.Must disconnect operator from power source BEFORE performing any service
or maintenance.
WARNING