8.1 To remove the two screws in both light lenses,then take both light lens out..
8.2 Insert two A19 incandescent or compact fluorescent light bulb (100 watt
maximum), or compact fluorescent (26W) into both light sockets.
8.3 Line up the lens taps with slots in operator, fasten it with the two screws.
9、Install the Emergency Release Cord and Knob
NOTE:
Ensure that the emergency release cord and knob are above
the top of
all moving objects to avoid entanglement.
9.1 Insert one end of the emergency release cord through the hole in the trolley
and tie a knot securely.
9.2 Insert the other end of the emergency release cord through the knob. Tie a
knot securely. Make sure the knob is 6 feet (1.83 m) above the floor. Cut off
the remaining cord.
9.3 Make sure the knots are tied securely. If cord knots become untied or loosen,
you could fall.
To avoid possible SERIOUS INJURY or DEATH from a falling garage door:
If possible, use emergency release to disconnect trolley ONLY when
garage door is closed. Deficient springs or unbalanced door could cause an
open door falling accident.
DO NOT use handle to drag door open or close.
Always make sure the doorway is clear of persons and obstructions.
To Next Page
Loading...
