Seaside 9357 - Program the Remote Control

36
6、PROGRAM THE REMOTE CONTROL
Note:
To open or close the garage door, press and hold button 1. When the garage door
begins to move, release button 1.
To stop garage door during travel, press and hold button 1 until door stops, then
release button.
To resume garage door travel after stop, press button again. Door begins to move in
the opposite direction.
6.1 Press the CODE Button on the setting
panel until the screen shows “●”.
6.2 Within 10 seconds, press the Button 1 on the remote control , the “●”will turn
off. Press the Button 1 again, the “●” will flash and turn off. Now, congratulation!
Button 1
LED
Button 2
T041-31
5