14
© 2013 SeaStar Solutions Optimus 360 Joystick Control System, Rev. C
These are supplied by the installer and may be mounted in a variety
of locations. Check near the batteries, in the circuit breaker box, or
near the pump control modules or hydraulic pumps. There should be
two 60 amp breakers for each PCM.
3.5 Circuit Breakers for Optimus 360 System
There is a display at each helm station that shows the system status
and allows system adjustments.
See Section 7.0 for CANtrak usage.
3.4 CANtrak Display
Figure 3-4. CANtrak display.