Seastar Solutions Optimus 360 Operation Manual

60
© 2013 SeaStar Solutions Optimus 360 Joystick Control System, Rev. C
11.0 Maintenance (continued)
After the first 200 hours or 12 months thereafter (whichever
comes first).
1. All points noted above.
2. Remove support rod from engine steering/tilt tube. Clean engine
steering/tilt tube and re-grease using a good quality marine
grease.
3. Grease support rod liberally.
4. Grease all contact points shown in the figure below. DO NOT remove
the tiller bolt to re-grease.
5. Remove the steering wheel(s) and re-grease the wheel shaft(s)
using a good quality marine grease.
6. Inspect hydraulic oil for cleanliness; flush if required.
7.
Check that the service valve is free to move and in the closed position.
ANY WORK BEING PERFORMED WITH THE STEERING SYSTEM MUST
BE COMPLETED BY A QUALIFIED MECHANIC WITH THE WORKING
KNOWLEDGE OF THE SYSTEM.
GREASE SUPPORTROD,
TILTTUBE&SUPPORT
BRACKET HOLE
GREASE SUPPORT ROD,
TILTTUBE&SUPPORT
BRACKET HOLE
Figure 11-1. Grease points on cylinder mounts.
WARNING

Seastar Solutions Optimus 360 Specifications

General

Brand	Seastar Solutions
Model	Optimus 360
Category	Automobile Electronics
Language	English