Seca 777 - Operation

Operation • 21
English
17-10-07-651-100a/07-2019S
1. Insert the connector plug of the plug-in power supply unit into the power
supply connection socket of the measuring station.
2. Plug the plug-in power supply unit into a power supply socket.
5. OPERATION
5.1 Switching the device on and off
Switching on the device
1. Ensure that there is no load on the measuring station.
2. Press the on/off key.
All the elements of the display are shown briefly, then
seca appears in the
display.
The measuring station is operational when
0.0 is displayed.
Switching off the device
► Press the on/off key.
NOTE
In battery operation, the measuring station remains on standby for
30 seconds. If there is no input or no load is put on the weighing plat-
form during standby time, the measuring station switches off automat-
ically.
5.2 Switching units of measurement (variant-dependent)
CAUTION!
Patient hazard
In order to avoid misinterpretations, measuring results for medical use
must be displayed and used in SI units (weight: kilogrammes, length:
metres) only. Some devices offer the ability to display measuring
results in other units. This is only an additional function.
► Use the results exclusively in SI units.
► The use of measuring results in non-SI units is the sole responsibility
of the user.
You can switch between the metric unit kilogram and the imperial unit pounds
during the measurement procedure.
1. Switch on the measuring station (➔ “Switching on the device”, page 21).