Seca 777 - Switching the Positions of the Display Unit and the Battery Compartment

Starting up device • 17
English
17-10-07-651-100a/07-2019S
NOTICE!
Damage due to assembly faults
If the cables are bent at too sharp an angle, they may be damaged
and thus cause a functional failure.
► Route all cables to prevent sharp bends and kinked connectors.
8. Connect the connecting cable:
a) Draw the connecting cable out of the column
b) Route the connecting cable past the cable clip and insert in the
socket on the weighing platform
c) Fix the connecting cable in position with the cable clip
9. Set the measuring station in an upright position.
Switching the positions of the
display unit and the battery
compartment
At the factory, the display unit is fitted to the right-hand operating side of the
display head. The battery compartment is on the left-hand operating side.
Proceed as follows to switch the positions of the display unit and the battery
compartment.
1. Remove the cover panel:
a) Unscrew two cross-head screws
b) Remove the cover panel
2. Remove the battery compartment lid:
a) Hold the battery compartment lid steady
b) Remove the cross-head screw behind the battery compartment lid
c) Remove the battery compartment lid
Right-hand
operating side
Left-hand
operating side