Operation • 23
English
17-10-07-651-100a/07-2019S
7. To deactivate the Tare function, keep the Tare key depressed until the
message
NET is no longer displayed.
NOTE
When you switch off the measuring station, the
Tare function is
deactivated automatically.
Displaying weight permanently
(Hold)
If you activate the Hold function, the weight value is displayed permanently.
1. Press the
Hold key.
The display flashes until a stable weight is measured. The weight value is
displayed permanently. The message
HOLD is displayed.
2. Read off the measuring result.
3. To deactivate the
Hold function, press the Hold key.
5.4 Measuring height
You can measure height using the integrated measuring rod.
CAUTION!
Injury from incorrect position of the measuring flap
Injuries may result if the measuring flap is at patient height when
folded up.
► Ensure that the measuring flap is above patient height before the
patient steps onto the weighing platform.
Measuring heights < 1.22 m When measuring heights < 1.22 m, the measuring result is read off under the
head slide (read-off edge 1).
1. Ensure that the upper telescopic element is in its lowest position.
2. Release the head slide by pressing on the latch and moving the head slide
downward.
To Next Page
Loading...
