follows: IM_SEC3_02.01_en.docx
58/70
4. With FUJI inverter
a. Verify speed and direction by checking led’s on SEC-3Q board (fig.3)
= UP direction
= speed ALARM
= speed pre-alarm
OK = speed OK
= DOWN direction
fig.3
If speed exceeds safety level = speed ALARM car will be automatically stopped;
if floor level has not been reached do not leave CFE key: brake will open again, may
be several times, until floor level will be reached.
in case of danger press red STOP button PSE
b. once arrived at nearest floor the car will automatically stop, and doors will open
c. leave CFE key then evacuate passengers
d. close and lock all the doors
e. inform the maintenance company
5. With VACON inverter
a. Verify speed and direction by checking the VACON keypad
i. if speed exceeds safety level brake will automatically close; if floor level has not
been reached do not leave the key: brake will open again, may be several times,
until floor level will be reached
ii. in case of danger press red STOP button PSE
b. once arrived at nearest floor the car will automatically stop, and doors will open
c. leave CFE key then evacuate passengers
d. close and lock all the doors
e. inform the maintenance company
To Next Page
Loading...