Step 3 – Network Connection
This step allows you to enter the information
for the SIM card to allow the processor to
communicate with a cellular Network.
The system will automatically Detect the SIM
card (1) and will present a green tick when it
is successful.
Note: If the detection is not successful, a red
“X” will appear with an error stating the SIM
is missing. Remove the SIM card tray, check
that the SIM is not damaged and inserted
correctly, then reboot the system by cycling
the power. Once the system boots back up
(approx. 90 secs) select the “Detect SIM”
button to clear the error.
Referring to your Installation Checklist, enter
the APN and Number details (2&3) for the
SIM card. These numbers must be correct.
If not, the system will not connect to the
network. If the numbers are not provided,
the PIN, Username and Password must be
left blank.
Note: Do not use a SIM that is not the
permanent SIM for the system as the
configuration file will not recognise it.
Select ‘Roaming’ data (4) if the client’s
cellular plan allows for this feature and the
vehicle is operating in a location where
connection may be limited between regions.
Select Verify APN (5) Setting to apply the
entered settings and gain network
connection.
Once the APN has been verified, the
Verifying APN Box will appear green, with a
green tick, and the statement ‘APN
Configuration verified and saved to Active
Config’ will appear. If the APN is not able to
be verified, you will need to confirm the APN
To Next Page
Loading...
