ID= Unit identification number (address) to the system.
Selectable between: 0-255
Default setting: 248
AutoPrn= Automatic printout of selected upper LCD indication once every second.
Refer to section 5.3 for printout examples.
- Yes
-No
Default setting: No
PW-Code= The SYSTEM DATA menu, NEW STARTUP menu and frontkey zerosetting of
subtotaliser 2 can be protected with a numerical password.
If entered, the password will be asked for when the menu is accessed the first time..
The password will only be asked for once for every session inside the menusystem.
When the menusystem is exited and reentered, the password will be asked for again.
If the password should be lost it cannot be retrieved. The back-up battery must be
temporarily removed, and the system restarted again with a new start-up.
Default value: 0 (inactivated)
Reg= Service registers. Intended for authorized service personnell.
Select reg. no and scroll down to “Reg Val=” to read and change value.
Note! any changes will be active immediately.
Reg Val= Current value of selected register.
Backup Backup all current settings to flash memory after completed start-up procedure and
final span adjustments etc.
This backup can be restored even after a memory battery failure.
Note! The restored data will include old time, date and totaliser values from the date
when the backup was saved.
- Yes
-No
18-08-16 S44-H15E 6-6
S-E-G SYSTEM A2-H15 INSTRUCTION
To Next Page
Loading...
Need help?
General