Seg WI Series - General Pickup, General Alarm, General Trip

Device planning
Selection list referenced by the following parameters:
• ╚═▷ DiggiMEC . Mode•
Device planning Description
“-” Do not use
DiggiMEC-A DiggiMEC variant A (1 󰅱ag indicator/output relay)
DiggiMEC-B DiggiMEC variant B (3 󰅱ag indicators/output relays)
Settings valid
Select which settings shall be valid: the settings made via Smart view/DiggiMEC or the
switches on the housing. \n(If set to “Switches”, then the respective default values are
always used for all settings that are not associated with any switch.) \nNote that getting
back from “Software” to “Switches” is not possible with this parameter, you have to execute
a Reset to Factory Defaults instead!
Selection list referenced by the following parameters:
• ╚═▷ Prot . Settings valid•
Settings valid Description
Switches The settings made via the switches are used.
Software The settings made via Smart view/DiggiMEC are used.
Device planning
Selection list referenced by the following parameters:
• ╚═▷ IH2 . Mode•
Device planning Description
“-” Do not use
use use
Device planning
Selection list referenced by the following parameters:
• ╚═▷ I> . Mode•
123WIC1WIC1-2.0-EN-REF
13 Selection Lists