Seg WIC1-3 User Manual

10.4.2
Operation of the Device
Description Information Corrective Action
The binary outputs or LEDs are in
unexpected state.
A binary output or an LED has
been recon󰅰gured from latched to
unlatched.
Try to reset the WIC1, e. g. via the Direct
Command [Operation / Reset] »Rst.
LEDs, FIs, Flt.Scr.«.
Independent of this, note that the set
value of »t-O󰅯 Delay« has to elapse
before the binary outputs / LEDs will
change their state.
Moreover, note that a latched state
even »survives« a restart of the device.
Smart view is set to the wrong
language (e. g. English).
You have installed Smart view with
English language. Now you want
to switch to a di󰅯erent language.
Select [Settings / Language] within
Smart view and select your desired
language. A window will pop up. This
informs you that the language will
get activated after a restart of Smart
view. Accept this information, close and
restart Smart view.
241WIC1WIC1-1.0-EN-MAN
10 Troubleshooting
10.4.2 Operation of the Device

Seg WIC1-3 Specifications

General

Brand	Seg
Model	WIC1-3
Category	Relays
Language	English