The CT type is set via the Direct Command »CT Type«.
• »CT Type« = “Relative” — Display of relative current values.•
• »CT Type« = “WE2 : 16 A ... 56 A”, … , “W6 : 256 A ... 896 A” — Display of primary•
current values, based on this CT type.
From this CT type setting, together with the setting of »In,relative«, results the
nominal current as a primary value, that is displayed at »CT pri«.
48 WIC1 WIC1-1.0-EN-MAN
2 WIC1 – Introduction and General Information
2.10 Measuring Values
To Next Page
Loading...
Need help?
General
