SYSTEM TEST MODE
39
3
SYSTEM TEST MODE
● The details of changes to SYSTEM TEST MODE settings are saved when you
exit from SYSTEM TEST MODE by selecting EXIT from the SYSTEM TEST MODE
screen. Be careful because if the power is turned off before that point, changes to
the settings will be lost.
● Use with the specied settings. If settings other than those specied are used,
inappropriate operations or malfunction may occur.
In the SYSTEM TEST MODE, you are mainly able to conrm the settings and functional status of the Nu, adjust the
monitor.
Displayed menu items cannot be selected while they are ashing. Wait until they are illuminated.
For details, see the Nu Service Manual, which is provided with the product.
Press the TEST Button to enter TEST MODE and bring up the GAME TEST MENU screen. Press the SERVICE
Button at the GAME TEST MENU screen and select SYSTEM TEST MODE. Then press the TEST Button to
display the SYSTEM TEST MODE screen.
Pressing the TEST Button before the application has started will display the SYSTEM TEST MODE screen directly,
without going through the GAME TEST MENU screen.
For this cabinet, set the COIN ASSIGNMENTS and NETWORK SETTING options in SYSTEM TEST MODE to
the following settings:
■ COIN SETTING
COIN CHUTE TYPE COMMON
SERVICE TYPE COMMON
COIN CHUTE #1 COIN TO CREDIT RATE 1 COIN(S) COUNT AS 1 CREDIT(S) OR FREEPLAY
■ NETWORK SETTING
DHCP ENABLE
Also, settings made through DETAIL SETTINGS are disabled. After the application has been rebooted, these will
revert to their default settings.
3
To Next Page
Loading...
Need help?
General
