LAMPS AND LIGHTING
13
91
3
Remove the Rear Access Panel and locate the Recovery Button. Once located, pull out the switch housing to
reveal the lamp to be replaced.
4
Once the Switch and Lamp Housing has been removed - pull out the LED (Do not twist) and replace with a
12V LED (White) of the same type.
2x PH #1 Machine Screws
Recovery Switch and Lamp housing
5
To re-t the Lamp housing, follow steps 1 to 4 in reverse order.
LED & LED Housing
Using index nger and thumb, pull out the
LED from its housing (Do not twist).
To Next Page
Loading...
