Sega Grid 42 - Shift Lever; Shift Lever Removal

62
CONTROL UNIT
10
If the shift lever switch input does not function correctly on the INPUT TEST screen, the switch may need to be re-
placed. To carry out this maintenance, you must rst remove the shift lever unit.
For this task, you will need a tamper proof wrench (for M5 screws), /and a Phillips-head screwdriver (for M4
screws).
● Whenworkingwiththeproduct,besuretoturnthepoweroff.Workingwiththe
poweronmaycauseanelectricshockorshortcircuit.
● Becarefulnottodamagethewires.Damagedwiresmaycauseanelectric
shock,shortcircuitorpresentariskofre.
1
Turn the power OFF
2
Using the M5 tamper proof wrench remove the four tamper proof screws, 1 located in each of the corner of
the Shift Lever.
3
Gently lift out the Shift Lever to reveal the wiring harness, locate the plug connecting it to the Control panel
and remove the connection. The Shift Lever can now be extracted.
4
When re-installing the Shift Lever follow the above instructions in the reverse order. At this time ensure that
the ‘DOWN’ display appears on the upper part of the Shift Lever as shown.
5
After the Re-installation of the Shift Lever, be sure to check the INPUT TEST in the Game Test mode to deter-
mine it’s correct operation.
10-2-1 SHIFT LEVER REMOVAL
10-2 SHIFT LEVER