EasyManua.ls Logo

Seip TM 50 - General Remarks; Useable Batteries; Changing the Transmitters Battery; Changing the Wall Push-Buttons Battery

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation Instructions TM50/TM80 - MO911/1V0
Page 17
General Remarks
!
Useable Batteries
Eine Batterie des Typs A23, 23A, 23L, EL12, VR 22 oder MN 21; Versorgungsspannung: 12V
Verbrauchte Batterien müssen nach den nationalen Bestimmungen entsorgt werden!
Changing the transmitters‘ battery
Open the transmitter Take off lid Change battery
Changing the wall push-buttons‘ battery
Open the wall push-button Change battery
A23S
12V
i
Range
The TM operator is equipped with a high quality remote control set as a standard!
However, the remote control is the part of the operator which might be inuenced by circumstances in the surroundings
of the garage� With our standard remote control you might reach a range of more than 100 meters�
The range is inuenced by:
- old batteries: if you should experience a problem with the range, please change the batteries rst� The lower the batte-
ries run the lower the range will be�
- Building materials of the garage: In a garage made of concrete and steel you might reach a lower range than in an ordi-
nary garage build of stone� The more steel was used for the walls the shorter the range of your remote-control�
Remote-control activity in the area: Radio and television transmitters close to your garage might reduce the range�
Older baby-phones and other household remote equipment: Some equipment like remote head-phones and baby-phone
might prodecure strong disturbant signals which could reduce the range of other remote devices�
It is extreemely unlikely that the range will drop to an unacceptable distance� If, however, problems should occure we will
like to be helpful�
Synchronisation of the Rolling Code
With each command given by a remote device a new code for the next command is created; this new code will be agreed
with the receiver� If a device is subsequently used for approx� 30 times out of reach of the receiver, then it will not be
accepted by anymore - the latest code is unknown to the receiver� The device must rst be registered with the operator
again in order to use it (refer to page 16)�
Remote Control
www.thegaragedoorcentre.co.uk
0800 525 442
www.thegaragedoorcentre.co.uk
www.thegaragedoorcentre.co.uk
0800 525 442
www.thegaragedoorcentre.co.uk

Table of Contents

Related product manuals