21
K600000000SE 030804 011018
8.3 Analyzer power supply
The instrument contains a high-capacity Li-Ion rechargeable battery.
The battery feeds the instrument, built-in printer and any other probes or remote devices that may be connected.
The instrument runs for approximately 18 hours if the printer is not used. Should the battery be too low to effect
the necessary measurements, the instrument can be hooked up to the mains via the power pack provided,
allowing operations (and analysis) to proceed. The battery will be recharged whilst the instrument is being used.
The battery charging cycle takes up to 3 hours for a complete charge and finishes automatically.
ATTENTION: If the instrument is not going to be used for a long time we suggest recharging it at least
once every 4 months.
8.3.1 Checking and replacing the batteries
The state of the internal battery can be displayed during the auto-calibration of the device and possibly later via
the information menu.
In the menu, the remaining battery power is displayed.
If battery charge appears to be low, let it discharge completely and then carry out a full 100% charge cycle by
connecting the instrument to the power pack for 3 hours.
If the problem persists, replace the battery pack with a SEITRON original or contact the SERVICE CENTER to
carry out the necessary repairs.
The average life of the battery pack is 500 charging/discharging cycles. To exploit this characteristic to the full it
is advisable to always use the instrument powered by the internal batteries and to charge it only when it gives the
battery flat message.
8.3.2 Use with external power pack
The instrument can work with the batteries fully discharged by connecting the external power pack provided.
8.4 QR code generation
By pushing at the same time the buttons + , the instrument generates and shows on the display a
QR code to download the data of the performed measures, after installing the App Seitron “SMARTFLUE LITE
MOBILE” downloadable from the AppStore or Google Play Store.
Minimum requirements for installing the App “SMARTFLUE LITE MOBILE”
Operative systems: Android from version 4.1
Apple (iOS)
THE POWER SUPPLY/BATTERY CHARGER IS A SWITCHING TYPE ONE.
THE APPLICABLE INPUT VOLTAGE RANGES BETWEEN 90Vac AND 264Vac.
INPUT FREQUENCY: 50-60Hz.
THE LOW VOLTAGE OUTPUT IS 5 VOLT WITH AN OUTPUT CURRENT GREATER THAN
1.5A.
LOW VOLTAGE POWER CONNECTOR: A-TYPE USB CONNECTOR + CONNECTION CABLE WITH B-
TYPE PLUG.
THE INSTRUMENT IS SHIPPED WITH THE BATTERY HALF CHARGED SO IT IS
ADVISABLE TO CHARGE IT COMPLETELY BEFORE USE, TAKING 3 HOURS.
IT IS ADVISABLE TO CHARGE THE BATTERY AT AN AMBIENT TEMPERATURE RANGING
BETWEEN 10°C AND 30°C.
THE INSTRUMENT GENERATES THE QR CODE ONLY WHEN THE INTERACTIVE
FUNCTION “ ” IS DISPLAYED ON SCREEN.
To Next Page
Loading...
