Seitron CHEMIST 600 - 2 Safety; Intended Use of the Product; Improper Use of the Product

7
K600000000SE 030804 011018
2.0 SAFETY
2.1 Intended purpose
This chapter describes the areas of application for which the CHEMIST 600 is intended.
Using the CHEMIST 600 in other application areas is on the risk of the operator and the manufacturer assumes
no responsibility and liability for loss, damage or costs which could be a result. It is mandatory to read and pay
attention to the operating/maintenance manual.
All products of the series CHEMIST 600 are handheld measuring devices in professional flue gas analysis for:
 Small furnaces (burning oil, gas, wood, coal)
 Low-temperature and condensing boilers
 Gas heaters
Due to other configuration with electrochemical cells it is possible to use the measuring instrument in following
application area:
 Service engineers/mechanics of burner/boiler manufacturers
 Service industrial combustion plants
The measuring instrument is approved for measurements under German regulations on immissons protection
(1. BImSchV)
1
.
Additional functions of the measuring instrument:
 Flue gas analysis according 1. BImSchV or qA-mean value (selectable)
 Calculating of stack heat loss and efficiency
 CO- and NO environment measurement
 Tightness test
 Store Smoke value, calculating mean value
 Measuring differential pressure
 Draft measurement
2.2 Improper use of the product
The use of CHEMIST 600 in application areas other than those specified in Section 2.1 "Intended use of the
product" is to be considered at the operator’s risk and the manufacturer assumes no responsibility for the loss
damage or costs that may result. It is compulsory to read and pay attention to the instructions in this use and
maintenance manual.
CHEMIST 600 should not be used:
 For continuous measurements > 1h
 As safety alarm instrument
1 Valid for configurations equipped with the following sensors:
O
2
sensor: Cod. AAC SE11
CO+H
2
sensor: Cod. AAC SE12
NO sensor (optional): Cod. AAC SE10.