Seitron CHEMIST 600 - Page 36

36
K600000000SE 030804 011018
10.2.5 Configuration→Analysis→Measurement units
Example:
Measurement unit can be set as: ppm - mg/m
3
- mg/kWh - g/GJ - g/m
3
- g/kWh - % - ng/J
Measurement unit can be set as: ppm - mg/m
3
- mg/kWh - g/GJ - g/m
3
- g/kWh - % - ng/J
Measurement unit can be set as: ppm - mg/m
3
- mg/kWh - g/GJ - g/m
3
- g/kWh - % - ng/J
Measurement unit can be set as: °C - °F
Measurement unit can be set as: hPa - Pa - mbar - mmH2O - mmHg - inH2O - psi
CONTEXT KEY FUNCTION
Enters the modification mode for the selected parameter.
Confirms the modification.
OK
KEY FUNCTION
Activate the context keys shown on the display.
Keys '▲' and '▼' select any line shown on the display (the selected line is
displayed in red).
When in modify mode, sets the desired value.
Enters edit mode of the selected element and then confirms the change.
When pressed in modify mode cancels the selection made, otherwise
returns to the previous screen.
OK
→
Pressure
hPa
Temperature
°C
SO
2
ppm
NO
X
ppm
CO
ppm
Configuration
Measure units
15/01/14
10:00
Pressure
hPa
Temperature
°C
SO
2
ppm
NO
X
ppm
CO
ppm
Configuration
Measure units
15/01/14
10:00
Pressure
hPa
Temperature
°C
SO
2
ppm
NO
X
ppm
CO
ppm
Configuration
Measure units
15/01/14
10:00
OK
Pressure
hPa
Temperature
°C
SO
2
ppm
NO
X
ppm
CO
Mg/m
3
Configuration
Measure units
15/01/14
10:00
OK
Pressure
hPa
Temperature
°C
SO
2
ppm
NO
X
ppm
CO
Mg/m
3
Configuration
Measure units
15/01/14
10:00