SEM SSD2-HS - Acceptable Materials and Feed Rates

508.366.1488 | www.semshred.com
13
Caution: Door to access the cutting chamber should always be locked while operating. As a safety feature,
opening this door during operation will immediately stop the machine; however, it may also cause a jam
and/or damage to the unit.
Warning: The SSD2-HS is designed to accept consumer SSDs with casing; however, enterprise SSDs must
be disassembled prior to destruction, including removing all capacitors and heat sinks. Consumer SSDs are
less than 3/8” thick and contain one PCB. Any SSD that is 3/8” or thicker is considered an enterprise drive
and must be disassembled prior to destruction.
Acceptable Materials and Feed Rates
Name
Photo
Description
Size
(Inches)
Feed
Rate
(pcs/min)
Throughput
(pcs/hr)
RAM
PC internal
memory sticks
without
heatsink
5.0 x
1.5
4
240
Thumb
Drive
PCB only
1.0 x
0.5
15
900
Thumb
Drive
Plastic or
metal casing
2.5 x
0.75 x
0.38
4
240
3.5” SSD
(consumer)
Consumer size
with metal
case (non-
enterprise,
one PCB only)
2.75 x
4.0 x
<0.3125
1
60
3.5” SSD
(enterprise)
PCB only:
enterprise
SSDs must be
disassembled
prior to
destruction
2.75 x
4.0 x
≥0.3125
2
120
Phone
Board
Cell phone
PCB
4.0 x
1.0
4
240