SEM SSD2-HS - Page 36

508.366.1488 | www.semshred.com
36
2. Using the 5/16” Allen drive socket bit, remove bolts from rotor knives and remove knives.
Figure 43. Bolts on one rotor knife
CAUTION: Knives are sharp.
3. Remove the bolts from the bed knives (Figure 44). Replace one knife at a time.
4. Wipe bed knife clean and place atop bed knife seat and blades facing rotor. NOTE: One knife will be
upside down.
Figure 44. Bed knife bolts
5. Wipe front and rear deflectors clean and place atop bed knives.