SPIDER ST1 Motorcycle Mesh Communication System | 32
10 CONFIGURATION SETTING
10.2.1 Headset Language
You can select the device language. The selected language is
maintained even when the headset is rebooted.
10.2.2 Audio Equalizer (Default: Off)
You can use the Audio Equalizer to increase/decrease the decibel level
of different frequency ranges of audio.
• Balance will adjust all of the frequency ranges to be the same volume
level (0 dB).
• Bass Boost will increase the bass range of audio (20 Hz - 250 Hz).
• Mid Boost will increase the mid range of audio (250 Hz - 4 kHz).
• Treble Boost will increase the high range of audio (4 kHz - 20 kHz).
10.2.3 VOX Phone (Default: Enable)
If this feature is enabled, you can answer incoming calls by voice. When
you hear a ringtone for an incoming call, you can answer the phone
by saying a word such as “Hello” loudly or by blowing air into the
microphone. VOX Phone is temporarily disabled if you are connected
to intercom. If this feature is disabled, you have to tap the Jog Dial or
the Phone Button to answer an incoming call.
10.2.4 VOX Sensitivity (Default: 3)
VOX Sensitivity can be adjusted depending on your riding
environment. Level 5 is the highest sensitivity setting and level 1 is the
lowest.
10.2.5 Intercom-Audio Overlay Sensitivity (Default: 3)
The music will be lowered to play in the background if you talk over the
intercom while the overlaid audio is playing. You can adjust the intercom
sensitivity to activate this background audio mode. Level 1 has the
lowest sensitivity and level 5 has the highest sensitivity.
Note: If your voice is not louder than the sensitivity of the selected
level, the overlaid audio will not be lowered.
To Next Page
Loading...
