Sennheiser HE 1 - Putting the HE 1 into Operation; Initial Setup and Ventilation

13
Putting the HE 1 into operation | Setting up the tube headphone amplier
Putting the HE 1 into operation
Setting up the tube headphone amplifier
CAUTION
Risk of staining of furniture surfaces!
Varnish or furniture polish may degrade the feet of the product, which could
stain your furniture.
▷ Do not place the product on delicate surfaces; if necessary, use a non-slip
pad under the product.
The installation location and the substructure have effects on the sound
quality. Observe the following notes:
▷ Place the tube headphone amplier on a stable, at, horizontal and low-vi-
bration surface that can safely carry the weight of the amplier.
▷ Ensure circulating ventilation. The amplier generates heat which is dissi-
pated through the housing, especially through the extended tubes. Do not
operate the amplier in closed cabinets.
▷ The power switch at the rear of the amplier must always be easily
accessible.
> 10
cm
>
5
c
m
45
°
<
6 m
45
°
21 kg