PXC 550 | 27
Using the headphones
Using the NoiseGard ANC
NoiseGard ANC is only available if the headphones and smartphone are
connected using Bluetooth or the USB cable.
The PXC 550 wireless headphones provide excellent attenuation of ambient
noise using Sennheiser’s very own NoiseGard active noise cancellation (ANC)
technology.
The PXC 550 wireless headphones also feature an innovative varying noise-
attenuation system called NoiseGard Adaptive ANC. If Adaptive ANC is used,
the NoiseGard strength is dependent on the severity of the surrounding noise
and will attenuate the noise accordingly. In Adaptive ANC, NoiseGard can be
very strong if the surrounding noise is too high, or can be very gentle if the
surrounding noise is too low.
Switching the NoiseGard ANC bet ween different modes
X
Indicates that the ANC is off.
X Indicates that the ANC is on.
The ANC attentuates the surrounding noise to the maximum.
X Indicates that the ANC is on adaptive mode.
The ANC attenuates the noise depending on the severity of the surrounding
noise.
In Adaptive ANC mode, you can adjust the strength of NoiseGard if you are
using CapTune on a smartphone that is connected wirelessly to the PXC 550
headphones.
Switching TalkThrough on/ off
TalkThrough allows you to communicate with other people without having to
remove the headphones and even when the NoiseGard ANC is switched on.
To switch TalkThrough on and off while listening to music:
X Briefly tap the touch control panel twice.
You hear
beeps in the headphones and the music pauses.
2x
To Next Page